B11-W

Description

The ENS Security B11-W junction box gives cameras a firm mounting base. Therefore, it works with select ENS camera models. This ENS camera junction box also keeps cable joints close to the camera. The unit is a white camera mounting box made from strong aluminum alloy. It also serves as an IP65 outdoor camera bracket for suitable sites.

The B11-W junction box is 109.5 mm wide and 38.5 mm high. It weighs only 162 g. Thus, it adds little weight to a wall or ceiling. The aluminum alloy junction box has a clean white finish. This finish matches many white cameras and light mounting surfaces.

The IP65 rating helps block dust and water. Still, correct setup and sealing are vital. The box can work from -40°C to 60°C. It can also work at 10% to 90% humidity. These limits suit many indoor and outdoor sites.

A white camera mounting box can make service work easier. It gives the installer room for cable joints. It also keeps those joints near the camera base. This setup can look cleaner than bare wires. The IP65 outdoor camera bracket can also help shield the cable entry point.

Installers should check camera fit before each job. They should also check the hole pattern and cable path. The wall or ceiling must support the camera and box. Screws, anchors, and seals must suit the mounting surface. Good seals are key for outdoor use.

Collsam Security supplies the genuine ENS Security B11-W for camera projects. This ENS camera junction box is compact, light, and easy to place. It combines a wide heat range with an IP65 rating. The B11-W junction box offers a neat way to mount a camera and manage its cable joints.